Icom | Ui7 Am Fm Unit Install

: Ensure the radio is completely disconnected from any power source to prevent electrical shorts.

: Use the supplied wire ties to organize the new harnesses, then replace the radio covers. Key Considerations

This is the scary part, but it’s easy. Use your plastic pry bar to gently pop up the factory speaker grille on the top-center of your dash. It is held in by four metal clips. Do not yank it; lift slowly and disconnect the factory speaker wire harness (if present). icom ui7 am fm unit install

Do you need advice on choosing the right for broadcast reception?

With the board installed and tested, you can safely put the radio back together. : Ensure the radio is completely disconnected from

Gently lift the cover away. If the cover houses an internal speaker, be careful not to yank the speaker wire. Carefully unplug the speaker cable from the main board if necessary, noting its orientation. Step 2: Locating the UI-7 Slot

Before buttoning up the case, perform a brief live-bench test to verify functionality. Powering Up Use your plastic pry bar to gently pop

The board usually only fits one way. Check your specific radio manual’s diagram to ensure the notch or pin 1 is aligned correctly.

Identify the designated connector slot for the option board. Carefully unpack the Icom UI-7 unit .

generally do not require this unit as the functionality is built-in. RigPix Database Specifications with UI-7 Installed Output Power 10–40 Watts 10–100 Watts Functionality Enables Transmit (Receive is standard) Enables both Transmit and Receive Tone Support Tone Encoder (requires UI-7 first)

Press down firmly and evenly on the edges of the UI-7 card until it clicks securely into place. Ensure the board sits perfectly level and parallel to the main board to avoid short circuits.