If the unit is not behaving as expected, consider these troubleshooting steps: Possible Cause No power ( 24V24 cap V ) to the unit Check power supply wiring and circuit breaker. One channel not working Bad switch contact or loose wire Verify continuity from switch to input terminal. All lights flickering Improper common wire connection
Set the hours and minutes for the event using the arrows, confirming each with .
Emphasizes that the device must be installed by a qualified electrician according to national standards. It warns that the device is not suitable for safe disconnection from the mains supply. Design and Layout: hager controls bp 10140 manual
Based on Hager’s naming conventions:
A hand icon or a specific indicator ( FIX ON / FIX OFF ) will appear on the display, confirming the manual override is active. Holiday / Vacation Mode If the unit is not behaving as expected,
- manual activation of the outputs on the device possible, building site operation - Status display of the outputs on the device - Device components - Hager
Run the Neutral wire of the load directly back to the main Neutral distribution bar. Programming Guide: Step-by-Step Instructions Emphasizes that the device must be installed by
The digital timer acts as an automated single-pole, double-throw (SPDT) switch. Connect the lines carefully using the screw terminal numbers on the housing: Powering the Timer (Control Supply) Connect the (typically blue) to terminal N .
Connect the phase (L) and neutral (N) to the respective load outputs according to the diagram in the manual.